Kingston Memory HX318C10FR/4 4GB DDR3 1866 Unbuffered HyperX Fury Red

(No reviews yet) Write a Review
1.00 LBS

Out of stock

Frequently bought together:


HyperX HX318C10FR/4 is a 512M x 64-bit (4GB) DDR3-1866 CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module, based on eight 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1866 at a low latency timing of 10-11-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:


• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 933MHz fCK for 1866Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 13, 11, 10, 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self-calibration through ZQ pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

• Height 1.291” (32.80mm) w/heatsink, single sided component

PnP JEDEC Timing Parameters:

• DDR3-1866 CL10-11-10 at 1.5V

• DDR3-1600 Cl9-10-9 at 1.5V

• DDR3-1333 CL8-9-8 at 1.5V CL (IDD)
10 Cycles
Row Cycle Time (tRCmin)
44.75ns (min)
Refresh to Active/Refresh Command Time (tRFCmin)
260ns (min)
Row Active Time (tRASmin)
32.125ns (min)
Maximum Operating Power
UL Rating
94V to 0
Operating Temperature
0 C to 85 C
Storage Temperature
-55 C to 100 C
Item Dimension (L"xW"xH")
3 x 7 x 1
1.00 lb
Warranty Information
Lifetime Manufacture
View AllClose